Furuno RC-1500-1T - Manual (Page 151)

7-11
5. Key in channel no. and press the [ENT] key. For example, press [1], [2], [3], [4] and [ENT] to
enter channel 1234. The channel selected is shown in black on white characters at the top of
the screen.
*** User ch entry **
!
MODE: NBDP
#
UP
$
DOWN
01234. TX: 0.0 RX: 0.0
01240. TX: 12666.0 RX: 13666.0
01241. TX: 12777.5 RX: 13777.5
01242. TX: 12999.5 RX: 13999.5
01250. TX: 12100.0 RX: 13100.0
"
CH: 12-34
6. Press the [ENT] key Enter Tx and press . Enter Rx frequency and press the [ENT] key. For
example, enter 12345.5 kHz as the Tx frequency and 13456.0 kHz as the Rx frequency.
** User ch entry **
! MODE : NBDP
# UP $ DOWN
01234. TX: 0.0 RX: 0.0
01240. TX: 12666.0 RX: 13666.0
01241. TX: 12777.5 RX: 13777.5
01242. TX: 12999.5 RX: 13999.5
01250. TX: 12100.0 RX: 13100.0
" CH : 12-34
TX : 0.0 KHZ
RX : 0.0 KHZ
7. The display shows the information entered. Using the examples mentioned in this procedure,
Tx frequency 12345.5, Rx frequency 13456.0 are registered to channel 1234.
*** User ch entry **
!
MODE: NBDP
# UP $ DOWN
01234. TX: 12345.5 RX: 13456.0
01240. TX: 12666.0 RX: 13666.0
01241. TX: 12777.5 RX: 13777.5
01242. TX: 12999.5 RX: 13999.5
01250. TX: 12100.0 RX: 13100.0
"
CH: 12-34