Furuno RC-1500-1T - Manual (Page 134)

6-4
6.2 Preparing Group Call Messages
1. Press the [#/SETUP] key to open the Setup menu.
2. Select MESSAGE and press the [ENT] key.
3. Press the [ENT] key to open the CALL TYPE menu.
* Message file entry
CALL TYPE
STATION ID
COM. TYPE
COM. FREQ
DSC FREQ
: INDIVIDUAL
: ---------
: TELEPHONE
: NO INFO
: 2M-INTL
INDIVIDUAL
PSTN CALL
GROUP CALL
AREA CALL
TEST CALL
4. Use  or  to select GROUP CALL and press the [ENT] key.
5. Press the [ENT] key to open the GROUP ID entry window.
* Message file entry
CALL TYPE:
GROUP ID
COM. TYPE
COM. FREQ
DSC FREQ
GROUP CALL
: 0 --------
: TELEPHONE
: NO INFO
: 2M-INTL
000000000
How to input group ID automatically
If you have previously registered some group IDs,
you can insert them into your message as follows:
1. Press the [FILE] key after completing step 4 in the
above procedure. The following display appears.
2. Select file which contains ID you want to use
(press
"
to show ID number).
3. Press the [ENT] key to insert ID number in message.
Group ID file
004. FURUNO
"
500. MARINE
"
777. ELECTRIC "
Note: You can print the
Group ID file list by pressing
the [8/PRINT] key.
#
UP
$
DOWN
6. Key in ID of group which is to receive the call and press the [ENT] key.
7. Press the [ENT] key to open the COM. TYPE menu.
* Message file entry
CALL TYPE:
GROUP ID
COM. TYPE
COM. FREQ
DSC FREQ
GROUP CALL
: 012345678
: TELEPHONE
: NO INFO
: 2M-INTL
TELEPHONE
NBDP-FEC
8. Select appropriate communications type and press the [ENT] key.
9. Press the [ENT] key to open the COM. FREQ menu.