Furuno RC-1500-1T - Manual (Page 208)

5-2
3. Input frequency pair. This can only be done with FURUNO
transceivers.
For other makes of transceiver, set a frequency pair at the trans-
ceiver. Omit steps 1, 2 and 3.
4. Press the [Enter] key.
5. Press function key [F3] again and then the [9] key. The follow-
ing screen appears.
Mode : ARQ FEC
ID :
Manual Calling
Figure 5-3 Manual calling screen
6. Select communication mode.
7. Press the [ ] key and input party's ID number.
8. Press the [Enter] key to connect the communication line. Then,
the line will be connected a short while.
For ARQ mode, follow the next procedure. For FEC mode,
type your message and go to step 13.
9. Press function key [F7] (WRU). The party's answerback code
appears on the screen.
Note: Step 9 and 10 are needed for ship to ship calling only.
10. Press function key [F8] (HR). You ship's answerback code is
sent to the party.
11. Press the [Enter] key and type your message.
12. If you want to the party's response, press function key [F9]
(Over).
13. Press function key [F10] to disconnect the line.