Furuno RC-1500-1T - Manual (Page 403)

A-13
Current State : Idle (pending!)
This message appears when a LES affir-
matively acknowledges your request for
PV testing.
Current State : Testing You will see this display during PV test-
ing.
DCE Error : No response from DCE!!
This message appears when you try to dis-
play the PV test results and there was no
response from the communication unit
because it is off or its interconnection cable
is disconnected or damaged.
Distress Message updated. Press any key.
This message appears after you have cor-
rectly updated the distress message.
Distress Alert Acknowledgment Received
This alert will appear when the LES trans-
mits the distress acknowledge signal to
your vessel.
FD not inserted in drive.
You need to insert a floppy disk into the
drive.
FD not inserted in drive. Press any key to escape.
This message appears if you attempt to
format a disk and there is no disk in the
drive.
File by that name already exists. OK to overwrite?
This alert asks you if it is alright to write
over an existing file name.
Formatting Completed. This alert appears upon completion of
floppy disk formatting.
Input Error : Message File
You have manually input an invalid file
name.
Internal GPS unit failure.
This message appears when the internal
installed GPS unit is not working or is
faulty. When the navigation port is not set
to “INT”, this message does not appears.
Invalid Frequency Code .
This message appears when a wrong fre-
quency code is entered in the EGC Chan-
nel List or NCS Channel List.
Invalid NCS ID Code. This alert appears when a wrong NCS ID
code is entered.
Loading Appears during loading of a file to a work-
ing area.