Furuno RC-1500-1T - Manual (Page 362)

5-2
2. Press [Enter] or [1] to display Data Report setting screen.
The cursor is on the Status line and “OFF” is selected.
Figure 5-2 Data report menu
3. Press [Enter] to open the selection window.
4. Select “ON” or “OFF”.
ON: Data report on
OFF: Data report off
5. Press [Enter] to close the selection window.
6. Press [ ] to advance the cursor to the Report Length line.
7. Press [Enter] to open the selection window.
8. Select “1” or “2”.
1: Position
2: Position, speed, bearing, depth
3: Spare (not used)
9. Press [Enter] to close the selection window.
10.Press [ ] to advance the cursor to the Destination line.
11. Press [Enter] to display the DNID list.
12.Select DNID.
(LES ID and Member ID are automatically selected with DNID.)
13.Press [Enter] to close the DNID list.
14.Press [ ] to advance the cursor to the Activation line.
15.Press [Enter] to open the selection window.
16.Select “Regular Interval” or “Daily”.
17.Press [Enter] to close the selection window.