Furuno RC-1500-1T - Manual (Page 295)

2-13
5. Press [Enter] to close the position window.
6. Press [
/
] to send the cursor to the Navarea line.
7. Press [Enter] to open the Navarea window.
Setup
EGC Setup
Receive EGC Area
Additional Position
Navarea
Fixed Area
Waypoint (from NAV Equipment)
NAVTEX
Station Code
Type of Message (Can’t reject other report)
Ice reports
Meteo. forecasts
Pilot service
DECCA messages
LORAN messages OFF
OFF
OFF
OFF
OFF OMEGA messages
SATNAV messages
Other navaid msg
QRU (no message) OFF
OFF
OFF
OFF
: :
OFF
Figure 2-22 EGC setup screen, Navarea window
8. Enter additional Navarea(s) (up to nine) for which you want to
receive broadcasts. Figure 2-23 shows the Navareas of the world.
Referring to the figure below for numeral and alphabet, enter ad-
ditional Navareas (up to nine) for which you want to receive broad-
casts.
Figure 2-23 Navareas
9. Press [Enter] to close the Navarea window.
10. Press [
/
] to send the cursor to Fixed Area.
11. This line is where you enter fixed areas (max. 3) for chart correc-
tion service. However, this service is not yet available; enter no
data.
12. Press [
/
] to send the cursor to the Waypoint line.