Furuno RC-1500-1T - Manual (Page 296)

2-14
13. Press [Enter] to open the Waypoint window.
Setup
EGC Setup
Receive EGC Area
Additional Position
Navarea
Fixed Area
Waypoint (from NAV Equipment)
NAVTEX
Station Code
Type of Message (Can’t reject other report)
Ice reports
Meteo. forecasts
Pilot service
DECCA messages
LORAN messages OFF
OFF
OFF
OFF
OFF OMEGA messages
SATNAV messages
Other navaid msg
QRU (no message) OFF
OFF
OFF
OFF
: :
OFF ON
OFF
Figure 2-24 EGC setup screen, waypoint
14. Select ON to receive broadcasts for the area of a destination
waypoint selected on the navigation device.
15. Press [Enter] to close the Waypoint window.
16. Press [
/
] to advance the cursor to the Station Code line.
17. Press [Enter] to open the Station Code window.
Setup
EGC Setup
Receive EGC Area
Additional Position
Navarea
Fixed Area
Waypoint (from NAV Equipment)
NAVTEX
Station Code
Type of Message (Can’t reject other report)
Ice reports
Meteo. forecasts
Pilot service
DECCA messages
LORAN messages OFF
OFF
OFF
OFF
OFF OMEGA messages
SATNAV messages
Other navaid msg
QRU (no message) OFF
OFF
OFF
OFF
: :
OFF
Figure 2-25 EGC setup, station code
18. Enter the navtex station code (A-Z) of the navarea. For details
about navtex stations, consult the operator’s manual of the navtex
receiver.
19. Press [Enter] to close the Station Code window.
20. Using the up/down arrow keys enable/disable reception of
NAVTEX broadcasts and press [Enter].
Note that navtex message types “Coastal navigational informa-
tion”, “Meteorological warning” and “Search and rescue alert”
(they do not appear on the display) cannot be deleted since they
are considered essential to navigation.