Furuno RC-1500-1T - Manual (Page 338)

4-8
13. Press [
/
] to send the cursor to the Option line.
14. Press [Enter] to open the option window.
<[1] UNTITLED1>
0001|t
Transmit
1. Transmit Message
2. Cancel
3. Request Delivery Status
Transmit Message
Priority
Message File
Station Name
Destination Type
Prefix Code
Country/Ocean Code
Station ID
Modem Type
Address
Subject
Attach File
LES ID
Option
[ TRANSMIT ]
Normal
Message now being edited Size 24
TELEX
201 (SANTA PAULA)
Confirmation
Send Delay
Delivery Delay
Code ON
00:00
Immediate
IA5
Figure 4-11 Transmit message menu, option window opened
15. Press [Enter] to open the selection window.
16. To receive confirmation from the LES when message has been
delivered to recipient, select ON. If not required, select OFF.
17. Press [Enter] to close the selection window.
18. Press [
/
] to send the cursor to the Send Delay line.
19. Press [Enter] to open the window for send delay entry.
20. To send a message after a certain delay enter a time up to 99 hours
59 minutes.
(The Send Delay is used to time message arrival to suit recipient’s
office hours.)
21. Press [Enter] to close the window.
22. Press [
/
] to go to the Delivery Delay line.
23. Press [Enter] to open the selection window.
24. The Delivery Delay line requests the LES for “Immediate” or
“Deferred” transmission to the recipient designated. Select either
immediate or deferred. For information on this service, consult
with LES to which message is to be sent.
25. Press [Enter] to close the selection window.
26. Press [
/
] to send the cursor to the Code line.
27. Select “IA5”, “ITA2” or “DATA”.
Normally, IA5.
28. Press [Enter] to close the selection window.
29. Press [Esc] to close the option window.
30. Press [
/
] to place the cursor on TRANSMIT.