Furuno RC-1500-1T - Manual (Page 192)

3-6
5. Press the [ ] key to advance the cursor to the Start Time line.
Enter start time in 24-hour notation. To have the operation start
at 8:35, for example, the keying sequence would be;
[0] [8] [3] [5] [0] [0]
6. Press the [ ] key to advance the cursor to the Stop Time line.
Enter stop time.
7. Press the [ ] key to advance the cursor to the Receive/Send
line. Select operation category; Receive or Send.
8. For send, insert floppy disk in drive and designate the file to
send. Press the [ ] key to advance the cursor to the File to
Send line. Press the [ ] key to display the file list, select a file,
and press the [Enter] key.
9. Press the [Enter] key.
10. Press the [Enter] key. The operation name appears in the Timer
Operation List. See note 2 and 3.
Note 1: To change a timer program, select it on the Timer Opera-
tion List, select Change and press the [Enter] key. Enter new data.
Note 2: If the operation name entered already exists, the display
shows the following message: Operation name already exists. Press
any key to escape. Press any key and change the operation name.
Note 3: If the station name entered has not been registered, the
display shows the following message: Station by that name does
not exists. Press any key to escape. Press any key and register the
station as shown on page 3-3.
Editing/Deleting Timer Programs
1. Press function key [F5] and the [2] key.
2. Select timer program from the Timer Program List.
3. Select Change and press the [Enter] key.
4. Do one of the following;
Edit program: Use [ ], [ ] and the [Backspace] key to
make corrections.
Delete program: Erase operation name with the [Backspace]
key.
5. Press the [Enter] key twice.
6. Press the [Esc] key.