Furuno RC-1500-1T - Manual (Page 321)

3-7
Saving a Message
Formatting a floppy disk
To save a message to a floppy disk the disk must be formatted. For-
matting prepares the disk no information can be written to its surface.
1. Insert a blank floppy disk into the disk drive.
2. Press [F1].
3. Press [8].
Figure 3-12 Format disk screen
4. Select media type.
5. Press [Enter].
Figure 3-13 FD Format confirmation screen
6. Select “Yes” to format the disk. Press [Enter] to begin formatting.
Note: If there is no floppy disk in the drive, “FD not inserted in
drive. Press any key to escape.” appears on the display.
7. “Now Formatting” appears on the screen during formatting.
8. When formatting is completed (about one minute), “Formatting
Completed.” appears on the display. You can now return to the
standby display by pressing any key.