Furuno RC-1500-1T - Manual (Page 217)

5-11
5.8 Timer Operation
A built-in timer permits automatic transmission and reception of
telex messages.
Enabling Timer Operation
1. Press function key [F3] to display the Operate menu.
2. Press the [7] key to display the Timer Operation List.
3. Select the operation (name) you wish to execute. Press the [En-
ter] key. An asterisk appears beside the operation selected and
"T. Op" appears in inverse video on the communication status
display. If a file from a floppy disk is to be sent, be sure the
floppy disk containing the file is inserted in the drive.
*1
2
3
OP4
OP5
Timer Operation List
Figure 5-10 Timer operation list
4. Select another operation (name) if desired.
5. Press the [Esc] key.
When the predetermined time comes, the DP-6 automatically sends
or receives messages. The results of timer operation are displayed
as either OK or NG (No Good) on the Timer Operation List.
*1
2
*3
*OP4
*OP5
OK
OK
OK
NG
Timer Operation List
Figure 5-11 Timer operation list
Stopping Timer Operation
1. Press function key [F3].
2. Press the [7] key.
3. Select the operation (name) which has asterisk attached to it
and then press the [Enter] key. Remove all asterisks to cancel
all timer programs.