YSI 5500D-1 - Manual (Page 122)

YSI 5X00
243
YSI 5X00
242
Index
ethernet 93
SMS messaging 98
force serial port 102
Network 98
RS232 baud rate 102
send test email 101
Configuration log 110
contactor. See Wiring contactor
Contact Us 238
Control board 44
Control menu 170
control modes 138, 139
Control modes
PID/PWM control mode 143
PID/PWM Tuning 146
set point control mode 139
D
Daily feedings (Feed Smart timer) 164
Daily weight (Feed Smart timer fcr) 165
Daily weight (Feed Smart timer-non fcr) 164
Data Logging menu
clear logs 113
event log 112
sensor log (data log) 110
Date and Time menu 114
Declaration of conformity 228
Defaults. See Factory defaults
device time out error. See Firmware Updater
DHCP (ethernet menu) 95
Display format (analog aux non temperature) 107
Display Settings menu 115
DNS address (ethernet menu) 97
DO sensor calibration mg/l 86
DO sensor calibration % sat 85
DO sensor setup 154
E
Email addresses (ethernet menu) 97
Email alarming 91
5400 email 91
AquaManager email 91
email retry delay 102
send test email 101
Ethernet menu 93
DHCP 95
DNS address 97
email addresses 97
gateway 96
IP address 95
port 96
subnet mask 96
Ethernet module
configure communications ethernet menu 93
installation 70
SMS messaging 98
Event logging 112
Event log view 172
Explorer window - AquaManager 178
F
Factory defaults 205
fcr (feed timer) 164
Feed Smart Timer
biomass 165
calibrate 167
daily feedings 164
daily weight 165
fcr
biomass 165
daily weight 165
fcr factor 165
feed % biomass 165
feed mode
continuous 162
timed 163
sensors 166
DO and temperature low/high % change 166
Firmware Updater
could not find unit error 122
device timed out error 122
Index