YSI 5500D-1 - Manual (Page 64)

YSI 5X00
127
YSI 5X00
126
Names can contain up to 20 characters.
Use AquaManager to easily configure names using the PC keyboard. See Aqua-
Manager On Line help.
1. Enter Name Devices/Sensors menu
Menus → System → Name Devices/Sensors
2. Use
▲ ▼
to scroll and highlight submenus.
3. Press

to select.
4. Use keypad to configure name.
5. Press to save configuration and return to Run Screen.
Notes:
- AquaManager users - Names uploaded in the temperature system name field
within the temperature system tab are displayed at the run screen, configura-
tion menus, and control messages menus.
- Instrument, Aux & Sensor Names are not cleared at Reset to factory menus.
- Relays names are cleared at “reset relays”, “reset all systems”, and “reset to fac-
tory/reset all” service menus.
- The 5X00 default system name is displayed at event, sensor, and calibration
logs, regardless if system name is user configured.
Configuring the 5X00
- At alpha/numeric keypad enter charcter then press “Clear” at keypad and then
press to clear user configured names.
- Non temperature aux system names can also be configured at: Menus → System
→ Configure Aux →Aux 1-6→Probe Name
- Because of font limitations, 1X2 and 2X3 display formats do not show all
20 characters of a 20 character name. Typically only 13 characters are dis-
played.
- The instrument name is not shown at Run Screen. The instrument name is
shown at relay enable menus.
- Certain menus (i.e. configure aux) display up to 18 characters of the device
name. “...” is shown at the menu if the name exceeds 18 characters.
Password
Menus → System → Password
Enable and set the password in the password menu. Once the password is enabled
and saved, 5X00 system menus are not accessible without first entering the correct
password at the Run Screen. The password can contain up to 12 characters.
request for password to enter menus password menu
1. Enter Password menu
Menus → System → Password
2. Use
▲
and
▼
to scroll and highlight submenus.
3. Press

to select.
4. Enable and configure submenus.
5. Press
to save configuration and return to Run Screen.
Notes:
- is not password protected.
Configuring the 5X00