YSI 5500D-1 - Manual (Page 45)

YSI 5X00
89
YSI 5X00
88
Note:
- Elevation is not required for mg/L Calibration.
System Menu
Menus → System
The 5400 System Menu contains 17 submenus. The 5500D-01, 5500D-02 and
5500D-04 System Menu contains 18 submenus*. Use System submenus to con-
figure non-sensor and non-timer systems. System submenus are shown below.
Press
at the Run Screen to enter the Main Menu. Use ▲ ▼ to scroll and
highlight a System submenu. Press 8 to select and enter a highlighted menu.
Configuration changes are saved when is pressed.
*”ODO Cal K” submenu appears in 5500D instruments only.
Notes:
- See Appendix 3 “Menu Maps” for system defaults and ranges (where applicable)
- starting on page 205.
- Menu configurations are saved to the instrument only after is pressed
and not when the change is made in the menu. If is not pressed, the
changes made to the configuration will not be saved. Exception - Date and
time and clear data logs are updated immediately to the system; however, YSI
recommends pressing
in this instance as well in order to save any
other changes that may have been made to the configuration.
5500
Configuring the 5X00
Adjust Contrast
Menus → System → Adjust Contrast
Use the Adjust Contrast menu to lighten or darken the display contrast.
1. Enter Adjust Contrast Menu:
Menus → System → Adjust Contrast
2. Use
▲
or
▼
to darken/lighten display.
3. Press

to confirm new display contrast.
4. Press to save configuration and return to Run Screen.
Notes:
- The display contrast will adjust automatically based on the 5X00’s internal
temperature.
- Contrast adjustment cannot be performed using AquaManager.
BackLight Timer
Menus → System → BackLight Timer
When the backlight timer is enabled, the backlight will turn on when any front
panel key is pressed and then turn off after the user configured backlighting timer
expires. If the backlight timer is disabled, the display backlight will not turn off.
Configuring the 5X00