YSI 5500D-1 - Manual (Page 79)

YSI 5X00
157
YSI 5X00
156
1. Install and wire DO probe(s) and membrane and/or sensor cap - page
50.
2. Configure DO system temperature source :
Menus → Sensor Setup→ DO 1-4→Temp Source→User Defined
→Aux 1-6
OR
Menus → System → Configure (Aux 3-6 only) →Temp Source →Aux Input
→ODO Probe
3. Configure Control Mode - page 138.
Menus → System → Sensor Setup→Set Point Control
→PID/PWM Control
5400
5500
4. Use
▲ ▼
to scroll and highlight submenus.
5. Press

to select.
6. Configure submenus.
7. Press
to save settings and return to Run Screen.
Note:
- Elevation data can only be viewed and configured locally at the 5500D instru
ment and cannot be viewed or configured using AquaManager.
5500
Configuring the 5X00 Configuring the 5X00