CONTREX CX-1200 - Manual (Page 110)

5 - 17
SCALING
This section discusses the setup procedures for scaling. The CX-1200 allows you to use Engineering Units
(e.g., feet, inches, revolutions) relative to a specific time (e.g., seconds, minutes) to control and monitor your
system. The scaling screens will walk you through the scaling of:
• the frequency inputs from the lead and feedback sensors
• the control output signal to the drive
• the lead and follower sync offsets & non-sync phase
• the lead and follower sync job sizes
• the Auxiliary Analog inputs (2) and output (1) signals
• the Scaled Fb (MP-40); which is the default parameter that appears in the large number display on the
status screen
Caution: To avoid damage to your system, the CX-1200 must be calibrated and the motor drive set up before you
operate your system. Refer to Drive Setup / Calibration: Calibration.
The CX-1200 scaling screens are:
• Lead
• Follower
• Offsets & Phase
• Job Sizes
• Aux Analog Input 1
• Aux Analog Input 2
• Aux Analog Output