CONTREX CX-1200 - Manual (Page 160)

5 - 67
BLOCK SETUP
The blocks are used as a quick access to a group of Control Parameters whose values will need to be changed
over the course of your system's operation. For example, the Blocks could be used to switch between speed
setpoints and ratio setpoints. You can assign up to sixteen Control Parameters to the blocks. There are eight
blocks that allow you to assign eight values to each of the sixteen Control Parameters. The blocks can be set
up so that the active block (the block currently in use) can be selected through a switch.
Caution: To avoid damage to your system, the CX-1200 must be calibrated and the motor drive set up before you
operate your system. Refer to Drive Setup / Calibration: Calibration.
The Block Setup screens are:
• Edit Block Parms
• Edit Blk 0
• Edit Blk 1
• Edit Blk 2
• Edit Blk 3
• Edit Blk 4
• Edit Blk 5
• Edit Blk 6
• Edit Blk 7