CONTREX CX-1200 - Manual (Page 224)

6 - 13
JOB SIZES P2/2
The Job Sizes screen (page 2) allows you to select and monitor the job sizes for the CX-1200. The first line
on the screen displays the current operating state.
State
State (MP-50) displays the present system operating state of the CX-1200 (see list below). Only one operating state
may be active at a time. To access either the “Run” or the “Jog” operating state, the F-Stop, R-Stop and H-Stop inputs
must be closed.
9 = Not Defined 8 = Diagnostics 7 = Not Defined
6 = Not Defined 5 = Jog 4 = Not Defined
3 = Run 2 = H-Stop 1 = R-Stop
0 = F-Stop
Cntrl Loop
Control Loop (MP-49) displays the present operating mode of the CX-1200. Only one type of loop can be active at a
time. These modes are automatically selected depending on the present system State (MP-50).
3 = Psn Hld (H-Stop Position Loop)
2 = Position Loop
1 = Velocity Loop
0 = Open Loop
Run Mode
Run Mode (CP-202) sets the mode of operation and the subsequent Setpoint, that are used when your system is in
“Run”. The Setpoint and mode of operation combined, determine the Reference Speed and, if applicable, the Refer-
ence Position. The modes of operation are:
4 = Inv Foll Mode
3 = Follower Mode
2 = Master Mode (default)
1 = Direct Mode
Sync Mode
Sync Mode (CP-203) selects the algorithm to be used when RUN Mode (CP-202) is set for Follower or Inverse Follower.
0 = Non-Sync Mode the position follower only, sync pulses are ignored by the control algorithm. 1 = Fixed Mode the
follower setpoint is the ratio/scale factor. 2 = Trend Mode the follower setpoint is altered by the control algorithm to
allow for continuously changing job sizes. 3 = Learn Mode learns the job spaces and the scale factor, also modifies the
follower setpoint.
3 = Learn
2 = Trend
1 = Fixed
0 = Off (default)
LdJSCnt
Lead Job Size Count (MP-182) displays LdJobSize (MP-11) in lines.
FbJSCnt
Follower Job Size Count (MP-192) displays the FbJobSize (MP-21) in lines.
LdJSAvgCt
Lead Job Size Average Count (MP-183) displays LdJbSzAvg (MP-14) in lines.
LdJSVarCt
Lead Job Size Variance Count (MP-184) displays LdJbSzVar (MP-12) in lines.
FbJSAveCt
Follower Job Size Average Count (MP-193) displays FbJbSzAvg (MP-24) in lines.
FbJSVarCt
Follower Job Size Variance Count (MP-194) displays FbJbSzVar (MP-22) in lines.