CONTREX CX-1200 - Manual (Page 98)

5 - 5
SETUP
The Setup screens allow you to perform a varitey of load, save and setup functions, The “Load” parameters
allow you to load Control Parameter values and the PLC program from either the backup or from the factory
default. The “Save” parameters allow you to save the Control Parameter values and the PLC program to a
backup copy. You can customize the Status screen for your specific requirements. The Serial
Communications Setup screen includes parameters that configure the serial communications port. When
Keypad Lock Input is active, Control Parameter values can not be changed. The Keypad Lockout Setup
screens allow you to specify which Control Parameters will be exempt from the lockout when the Keypad
Lockout Input is active.The Video Setup screen includes the parameters that control the screen operation.
Display Setup contrast and adjust the pixel intensity of the screen display. The Alarm Indicator Mask screen
includes the parameters that determine which alarms and which numerical comparator outcomes will cause the
‘alm’ to flash in the lower-left corner of the screen. The DeviceNet setup includes Control Parameters for
DeviceNet network communications.
Caution: To avoid damage to your system, the CX-1200 must be calibrated and the motor drive set up
before you operate your system. Refer to Drive Setup / Calibration: Calibration.
The Setup screens are:
• Status Screen Setup
• Load and Save Parms
• Remote Scroll Setup
• Keypad Lock Setup
• Serial Comm Setup
• DeviceNet Setup
• Video Setup
• Alm Indicator Mask