IAI America PCON-CFA User Manual

Page 147

Advertising
background image

3. SCON-CA/CF

A


141

CompoNet

(29) Acceleration/deceleration mode (MOD1, MOD0) PLC output signal

This signal is used to select the acceleration/deceleration pattern characteristics. Select one of them before
the actuator movement command.

MOD1 MOD0

Pattern

name

Remarks

OFF

OFF

Trapezoid Pattern

Factory setting

OFF ON

S-shaped

Motion

ON

OFF

First-Order Lag Filter

ON ON

Unavailable

Trapezoid Pattern





*The Acceleration and Deceleration are set in the “Acceleration” and “Deceleration” data boxes on the position

data.

S-shaped Motion

The S-shaped curve is described where at first in the acceleration, the line is gentle, but along the way, it
suddenly becomes steep.
Use it in such application that setting the acceleration/deceleration rate high is desired because high tact
time is required, but in the movement start or immediately before stop, low acceleration/deceleration rate is
favorable.





* The S-shaped motion degree is set using the parameter No. 56 “S-Shaped Motion Ratio Setting”. The

setting unit is % and setting range is from “0” to “100”.

(The above figure shows the image graph with the Parameter No. 56 set to “100”.)
When it is set to “0”, the S-shaped motion is disabled.
However, the setting is not reflected on the jog operation or inching operation performed using the teaching

tools such as PC.

First-Order Lag Filter

This describes much gentle acceleration/deceleration curve than that for the linear acceleration/deceleration
(trapezoid pattern).
Use it when it is not desired to give any slight vibration to the work part in acceleration/deceleration
operation.





* The first-order lag degree set using the parameter No. 55 “Position Command Primary Filter Time Constant”.

The minimum input unit is 0.1msec and setting range is from “0.0” to “100.0”.

W hen it is set to “0”, the first-order lag filter is disabled.
However, the setting is not reflected on the jog operation or inching operation performed using the teaching

tools such as PC.

Velocity

Acceleration

Deceleration

Time

Velocity

Time

Velocity

Time

Advertising
This manual is related to the following products: