Yokogawa DR240 - Manual (Page 137)

9-14 IM DR231-01E
9.3 Alarm Acknowledgment, Alarm Reset, Timer
Reset, Computation, Keylock, and Message
Printout
D I S P M O D E
P R I N T F U N C
I N S D E L
R A N G E A L A R M
S E T C H A R T E N T E R
F E E D
M. F U N C 1
M. F U N C 2
RECORD
ALARM
CHART
KEYLOCK
R E C O R D
TIMER_RESET
>Select Function item
E S C
• Press the FUNC key to enter the FUNC menu.
• To enter the FUNC menu from the RANGE, ALARM, CHART or SET (SET3) menu, press
the DISP key.
• Select/set using the keys.
• To escape from a lower menu, press the MODE (ESC) key. Its main menu will appear,
although new settings/selections will not be kept.
• There may be some menus that are not displayed due to the basic settings as described in
Chapter 10.
ALARM ACK
ALARM RST
TIMER RESET
MATH START *1
MATH CLR START
MATH STOP *2
MATH ACK *3
KEY LOCK ON
MSG PRINT
ENTER O p e r a t i n g s t a t u s
ENTER
ENTER
ENTER
ENTER
( M a i n m e n u )
PRINT MESSAGE No.=01 ENTER ENTER
ENTER
ENTER
( L o w e r m e n u )
A CODE NUMBER=2888 ENTER ENTER
*1: Displayed when computation is not in progress.
*2: Displayed when computation is in progress.
*3: Displayed when incomplete measurement occurs while computation is in progress.
Note
• If MATH is selected as a level action, MATH START, MATH CLR START and MATH STOP will not
be displayed.
• The displayed information varies depending on the settings given in Section 10.8, "Setting FUNC/
FUNC3 Menu." The flow of operation shown above is the one given when the recorder is in the default
state.