Yokogawa DR240 - Manual (Page 155)

10-13 IM DR231-01E
Basic Settings (SET-UP)
10
Setting Burn-out (BURN OUT)
Set the dot-printing position when burn-out occurs for each channel.
• OFF: the burn-out function is not actuated.
• DOWN: a dot is printed at the end of chart width on the minimum value setting side of the
recording span.
• UP: Dot is printed at the end of chart width on the maximum value setting side of the recording
span.
• The default setting is OFF.
Setting Reference Junction Compensation (RJC)
Set either the internal or the external compensation for each channel.
• INT: internal compensation is performed.
• EXT: external compensation is performed. For external compensation, set the voltage to be
compensated.
Voltage to be externally compensated: set in the range of -20000 to 20000 mV.
• The default setting is INT.
Note
• In order to make the set or selected contents effective, the contents must be registered. For details, see
page 10-24.
• To return from the SET UP menu to the operation display mode, select END in the main menu. For
details, see page 10-24.
10.5 Setting Burn-out/Reference Junction Compensation