Yokogawa DR240 - Manual (Page 83)

4-7 IM DR231-01E
Setting the Monitor Mode Display
4
4.4 Using the ALARM SEARCH Display
D I S P
P R I N T F U N C
I N S D E L
R A N G E A L A R M
S E T C H A R T E N T E R
F E E D
M. F U N C 1
M. F U N C 2
R E C O R D M O D E
E S C
ALARM SEARCH Display for the Main Display
1 Select the main display using the DISP key.
2 Select “SER” using the MODE key.
003 0.0054V 004 0.0319V SER
Sub-display 1
ALARM SEARCH Display for Sub-display 1
1 Select sub-display 1 using the DISP key.
2 Select “SER” using the MODE key.
004 H 0.0269V 005 RH 0.0248V
Sub-display 1
SER
ALARM SEARCH Display for Sub-display 2
1 Select sub-display 2 using the DISP key.
2 Select “SER” using the MODE key.
005 0.2108V 006 0.0951V
Sub-display 1
SER
ALARM SEARCH Display for the Main Display
Only the channels in which an alarm occurred, will be displayed. When an alarm occurs in several
channels, the channels will be displayed consecutively.
• Channel No., Difference between Channels (delta), Alarms, Measurement Values
and Engineering Units
Same as for the AUTO mode (refer to page 4-2).
• Others
When the input types of all channels are set to “SKIP” or no alarms occur, “***NO
ALARM***” will be displayed.
ALARM SEARCH Display for the Sub-display 1 and 2
Only the channels in which an alarm occurred, will be displayed. Two channels will be displayed
on each sub-display.
• Channel No., Difference between Channels (delta), Alarms, Measurement Values,
Engineering Units and Selected Display Mode
Same as for the AUTO mode (refer to page 4-3).