Yokogawa DR240 - Manual (Page 186)

11-10 IM DR231-01E
Reading data from a floppy disk
To read data from a floppy disk, it is necessary to copy the data from the floppy disk to the RAM
disk. However, data in ASCII format cannot be read. See section 11.5, “Copying a Data File,”
for more information.
Status display during reading
The following status symbols are displayed in the sub-display 2 (lowest display section).
It is not possible to make media settings other than reading stop setting while measured/computed
data is being read. See Section 11.5, "Copying a Data File," for more information.
M : Reading is in progress.
T : Awaiting a trigger
11.2 Reading Measured and Computed Data