Yokogawa DR240 - Manual (Page 82)

4-6 IM DR231-01E
4.3 Using the PAGE Display
D I S P
P R I N T F U N C
I N S D E L
R A N G E A L A R M
S E T C H A R T E N T E R
F E E D
M. F U N C 1
M. F U N C 2
R E C O R D M O D E
E S C
1 Select the main display using the DISP key.
2 Select “PGE” using the MODE key.
002 0.1936V 003 0.0995V PGE
Sub-display 1
3 Select the required set of five channels (page) using the keys.
007 0.0197V 008 0.0074V PGE
006 V 0.0173
009 0.0162V 010 0.0102V
Display
PAGE Display for the Main Display
When this display is selected, the measurement values of five consecutive channels will be
displayed using sub-display 1 and 2 also.
• Channel No., Difference between Channels (delta) and Alarms
Same as for the AUTO mode (refer to page 4-2).
• Measurement Values
Same as for the AUTO mode (refer to page 4-2), except for the following.
When the input type of the channel is set to “SKIP”, then “SKIP” will be displayed.
When the channel other than the channel of the input module is selected, “- - - - - -” appears.
• Engineering Units
Same as for the AUTO mode (refer to page 4-2), except for the following.
When the input type of the channel is set to “SKIP”, then no engineering unit will be displayed.
PAGE Display for the Sub-display 1 and 2
In combination with the page display of the main display, data of two channels are displayed here
simultaneously on each display. Other display modes cannot be selected.
• Channel No., Difference between Channels (delta), Alarms and Selected Display
Mode
Same as for the AUTO mode (refer to page 4-3).
• Measurement Values
Same as for the AUTO mode (refer to page 4-3), except for the following.
When the input type of the channel is set to “SKIP”, then “SKIP” will be displayed.
When the channel other than the channel of the input module is selected, “- - - - - -” appears.
• Engineering Units
Same as for the AUTO mode (refer to page 4-3), except for the following.
When the input type of the channel is set to “SKIP”, then no engineering unit will be displayed.