Yokogawa DR240 - Manual (Page 188)

11-12 IM DR231-01E
Saving set-up data for the SETUP mode
D I S P M O D E
P R I N T F U N C
I N S D E L
R A N G E A L A R M
S E T C H A R T E N T E R
F E E D
M. F U N C 1
M. F U N C 2
RECORD
ALARM
CHART
KEYLOCK
R E C O R D
SETUP=FLOPPY
PRN_ADJ SCAN_INTVL RECORD MATH FLOPPY
>Select Setting Parameter
E S C
• Carry out the following steps to enter the SET UP menu.
1. If the SET UP menu is not currently displayed, turn the power OFF
2. While holding the DISP key, turn the power ON. Make sure depression of the DISP key is
maintained for approximately another five seconds..
• Select/set using the keys.
• To escape from a lower menu, press the MODE (ESC) key. Its main menu will appear,
although new settings/selections will not be kept.
SET UP=
(Main menu)
FLOPPY FLOPPY=SAVE
SAVE LOAD DELETE INFO FORMAT
SAVE file=
_____ AAA BBB CCC
SAVE FILE=AAA
Saving... *
***SAVE OK*** (End of saving) ESC
ENTER
ENTER
ENTER ENTER
Set-up data except for date/time is saved to the internal RAM disk or a floppy disk. Set-up data
for the SETUP mode can be saved to a floppy disk only. Data is always saved in ASCII format.
The file name must consist of up to 8 characters. The following identifier is used.
Set-up data file for SET mode : .PNL
Set-up data file for SETUP mode : .SET
Data size
• DR130
Set-up data for SET mode : up to approximately 42 KB (20 measurement channels and 30
computation channels)
Set-up data for SETUP mode : up to approximately 13 KB (20 measurement channels and 30
computation channels)
• DR230
Set-up data for SET mode : up to approximately 50 KB (30 measurement channels and 30
computation channels)
Set-up data for SETUP mode : up to approximately 15 KB (30 measurement channels and 30
computation channels)
Note
• “Saving ...*” will be displayed during saving. During this period, key board operations are not possible.
• No data saving is possible during computations.
• During saving, GP-IB/RS-232-C/RS-422-A/RS-485 communication remains inactive.
11.3 Saving Set-up Data