Yokogawa DR240 - Manual (Page 85)

4-9 IM DR231-01E
Setting the Monitor Mode Display
4
4.5 Using the BARGRAPH Display
D I S P
P R I N T F U N C
I N S D E L
R A N G E A L A R M
S E T C H A R T E N T E R
F E E D
M. F U N C 1
M. F U N C 2
R E C O R D M O D E
E S C
1 Select the sub-display 1 using the DISP key.
2 Select “BAR” using the MODE key.
- 1.5000> < 2.0000 BAR
003 V 0.0172
004 0.0153V 005 0.0123V
Display
Bargraph Display
Sub-display 1 can be turned into a bargraph display.
The measurement data on the main display are displayed as a bargraph on sub-display 1. The
bargraph shows a graph corresponding to the measurement value, showing the recording span
divided into 40 equal parts. The left side of the bargraph shows the left span, the right side of the
bargraph shows the right span. When you are using the linear scaling function, the left and right
side of the bargraph show the left scaling and right scaling value respectively. Engineering units
are not displayed.
When the main display shows “SKIP”, “***ALL SKIP***”, “NO ALARM”, “OOOOOO”,
“XXXXXX”, or “- - - - - -” the bargraph will not appear. Only the selected display mode will
appear.