Yokogawa DR240 - Manual (Page 169)

10-27 IM DR231-01E
Basic Settings (SET-UP)
10
10.12 Working with the Report Function
D I S P M O D E
P R I N T F U N C
I N S D E L
R A N G E A L A R M
S E T C H A R T E N T E R
F E E D
M. F U N C 1
M. F U N C 2
RECORD
ALARM
CHART
KEYLOCK
R E C O R D
SETUP=REPORT
↓ CORD MATH FLOPPY REPORT ALARM A/D_INTG ↑
>Select Setting Parameter
E S C
• To enter the SETUP menu, follow the steps below:
1. If the DR recorder is in the OPERATION/DISPLAY mode or shows a menu other than the
SETUP menu, turn off the power switch once.
2. Turn on the power switch while pressing down the DISP key, and then keep holding the key
down for approximately five seconds.
• Using and , select and/or enter a value for each of the shaded fields shown below.
• To exit any of the following menu items during the procedure, press the MODE (ESC) key.
This returns to the first item of the menu. Note however that your new settings and selections
are canceled.
• Reaching the step showing the message “***REPORT SET***” or “***REPORT CH
SET***” confirms the latest settings/selections.
Sending the Instantaneous Value and Average to a Report Output
MODE=SET
SET CH_SET PRINT
HOURLY REPORT=OFF
OFF ON
DAILY REPORT=ON1
OFF ON1 ON2
MONTHLY REPORT=ON1
OFF ON1 ON2
START TIME=01 00 : 00
***REPORT SET***
(configuration complete)
MODE=CH_SET
SET CH_SET PRINT
REPORT CH=R01
R01 R02 R03 R04 R05 R06 R07 R08 R09 R10 ↑
R01=ON : 001
OFF ON
R01=ON : 001
CALC MODE=AVE
INST AVE SUM
***REPORT CH SET***
(configuration complete)
SETUP=ABORT
ABORT STORE
REPORT
END
ENTER ENTER
(Main menu item)
(Submenu items)
SET UP=
ENTER
ENTER
ENTER
ENTER
ESC
ENTER
ENTER
ENTER
(Completes the configuration
of the SETUP menu)
ENTER
ENTER
ENTER
ESC
ESC