Yokogawa DR240 - Manual (Page 161)

10-19 IM DR231-01E
Basic Settings (SET-UP)
10
Setting FUNC/FUNC3 (FUNC PARM)
Select the menu to be displayed by pressing the FUNC key whether in the FUNC menu or the
FUNC3 menu. The FUNC menu is displayed by pressing the FUNC key at a touch and the
FUNC3 menu is displayed by pressing the FUNC key for about 3 seconds continuously.
• Select any of the following:
• FUNC: displayed in the FUNC menu.
• FUNC3: displayed in the FUNC3 menu.
• OFF: not displayed in either menu.
• The default setting is as shown in the operating procedure diagram on pages 10-17 and 10-18.
• The last operation menu, “PANEL:ALL ITEM” is the menu that globally set all menus.
However, the selection of “INIT” selects the default setting.
• The “COMM INF” menu is displayed for instruments with the communication option.
Note
• In order to make the set or selected contents effective, the contents must be registered. For details, see
page 10-24.
• To return from the SET UP menu to the operation display mode, select END in the main menu. For
details, see page 10-24.
10.8 Setting FUNC/FUNC3 Menu