Yokogawa DR240 - Manual (Page 139)

9-16 IM DR231-01E
9.4 Clearing Alarm/Message Buffers, and Displaying and
Initializing Module/Communications Information
D I S P M O D E
P R I N T F U N C
I N S D E L
R A N G E A L A R M
S E T C H A R T E N T E R
F E E D
M. F U N C 1
M. F U N C 2
RECORD
ALARM
CHART
KEYLOCK
R E C O R D
ALM_BUF_CLEAR
>Select Function item
E S C
↓ ALM_BUF_CLEAR MSG_BUF_CLEAR MODULE_INF ↑
• Press the FUNC key for three seconds to enter the FUNC3 menu.
• To enter the FUNC menu from the RANGE, ALARM, CHART or SET (SET3) menu, press the
DISP key.
• Select/set using the keys.
• To escape from a lower menu, press the MODE (ESC) key. Its main menu will appear,
although new settings/selections will not be kept.
• There may be some menus that are not displayed due to basic settings as described in Chapter
10.
ALM BUF CLEAR
MSG BUF CLEAR
MODULE INF
COMM INF
RAM INIT
INF=SYSTEM
SYSTEM REAL
MODULE=GP-IB
>ADDR=01
MODULE=RS-232C
>BIT RATE=19200 LENGTH=8BIT PARITY=NONE
>STOP=1BIT HANDSHAKE=OFF:OFF
RAM INIT=NO
RAM INIT=YES
RAM INITIALIZING
ENTER O p e r a t i n g s t a t u s
ENTER
ENTER ENTER
ENTER
ENTER ENTER
ENTER
( A f t e r a b o u t 1 0 s e c o n d s )
ENTER
( F o r G P - I B i n t e r f a c e )
( F o r R S - 2 3 2 - C i n t e r f a c e )
ENTER
( M a i n m e n u )
( L o w e r m e n u )
Note
• The displayed information varies depending on the settings given in Section 10.8, "Setting FUNC/
FUNC3 Menu." The flow of operation shown above is the one given when the recorder is in the default
state.