Yokogawa DR240 - Manual (Page 91)

5-2 IM DR231-01E
ENTER
ESC
ENTER
001-01:DI/LEVL
001-01:DI/LEVL
LEVL CONT
SPAN= _ _ _ _ _ _ 0/ _ _ _ _ _ _ 1
>Span limit(0~1)
***SET OK***
002-02:DELTA/REF Ch=01
002-02:DELTA/REF Ch=01
>Select Channel No.
SPAN= -2.0000/_2.0000V
>Span limit(-2.0000~2.0000V)
***SET OK***
002-02:RRJC/RJC Ch=01
002-02:RRJC/RJC Ch=01
>Select Channel No.
SPAN= 0.0/1760.0˚C
>Span limit(0.0~1760.0˚C)
***SET OK***
ENTER
ENTER
ENTER
ESC
ESC
From the previous page
ENTER
Setting the Channel No.
This setting specifies the channels to which the type of input and recording span applies. You can
set a range of channels by specifying the first (begin) and the last channel (end).
First Channel No. (Begin)
The first three characters on the main display show the number of the first channel to which
settings apply.
Default is “001”, and the first character is always “0”. The setting ranges from 001 to the
maximum number of input channels of your unit (010 for 10 input channels; 020 for 20 input
channels; 030 for 30 input channels).
Last Channel No. (End)
The two characters following the first channel number show the number of the last channel to
which settings apply.
Default is “01”. The setting ranges from 01 to the maximum number of input channels of your
unit. The number of the last channel cannot be smaller than the number of the first channel. When
both channel numbers are equal, settings will only apply to that particular channel. When you
have set the first channel number and you move the cursor to the last channel setting, the channel
number of the first channel setting will appear here.
5.1 Setting the Type of Input and Recording Span