NORD Drivesystems BU0500 - Manual (Page 111)

5 Parameters
BU 0500 GB-1013 111
P481
[-01]
...
[-10]
Function BusIO Out Bits
(Function of Bus I/O Out Bits)
S
0 ... 39
{ all 0 }
The bus I/O Out bits are perceived as digital outputs (P434). They can be set to the same
functions.
In order to use this function, one of the bus setpoints (P543) must be set to >Bus I/O In Bits 0-7
<. The required function must then be assigned to the relevant bit.
With the SK 54xE in association with IO extension modules these I/O bits can also process their
input signals.
[-01] = Bus I/O Out Bit 0
[-02] = Bus I/O Out Bit 1
[-03] = Bus I/O Out Bit 2
[-04] = Bus I/O Out Bit 3
[-05] = Bus I/O Out Bit 4 (or SK54xE and above: + DO1 of the first IOE)
[-06] = Bus I/O Out Bit 5 (or SK54xE and above: + DO2 of the first IOE)
[-07] = Bus I/O Out Bit 6 / Flag 1 (or SK54xE and above: + DO1 of the second IOE)
[-08] = Bus I/O Out Bit 7 / Flag 2 (or SK54xE and above: + DO2 of the second IOE)
[-09] = Bit 10 BUS status word
[-10] = Bit 13 BUS status word
The possible functions for the Bus Out Bits can be found in the table of functions for the digital
outputs or the relays.
For further details, please refer to the manual for the AS interface, BU 0090.
Pos : 257 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P400-P499/ Paramet er P482 – N or mier ung Bus I /O Out Bits [SK 5xxE] @ 0\ mod_1328002779143_388. doc x @ 10825 @ @ 1
P482 [-01]
...
[-10]
Norm. BusIO Out Bits
(Scaling of bus I/O Out bits)
S
-400…400 %
{ all 100 }
Adjustment of the limit values of the relay functions/Bus Out Bits. For a negative value, the output
function will be output negative.
When the limit value is reached and the setting values are positive, the relay contact closes, with
negative setting values the relay contact opens.
The assignment of the arrays correspond to those of parameter (P481).
Pos : 258 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P400-P499/ Paramet er P483 – H yst eres e Bus I /O Out Bits [SK 5xxE] @ 0\ mod_1328002828441_388. doc x @ 10848 @ @ 1
P483
[-01]
...
[-10]
Hyst. BusIO Out Bits
(Hysteresis of bus I/O Out bits)
S
1…100 %
{ all 10 }
Difference between switch-on and switch-off point to prevent oscillation of the output signal.
The assignment of the arrays correspond to those of parameter (P481).
Pos : 259 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ P5xx Z us atz par ameter @ 0\ mod_1328091531180_388. doc x @ 10880 @ 5 @ 1