NORD Drivesystems BU0500 - Manual (Page 13)

1 General
BU 0500 GB-1013 13
1.2 Delivery
Check the equipment immediately after delivery/unpacking for transport damage such as deformation
or loose parts.
If there is any damage, contact the carrier immediately and carry out a thorough assessment.
Important! This also applies even if the packaging is undamaged.
Pos : 20 /Anl eitungen/ Elektroni k/FU und Start er/ 1. Allgemei nes/ 1. 3 Lief erumfang [ BU 0500] @ 0\ mod_1325780384629_388. doc x @ 5362 @ 2 @ 1
1.3 Scope of delivery
Standard version: IP20
Integrated brake chopper
Integrated EMC mains filter for limit curve A1 as per EN55011
devices)
Blanking cover for technology unit slot
Screening terminal for control terminals
Covering for the control terminals
Size 1 to Size 7: Accessory bag with wall mounting brackets
Size 8 and above: miscellaneous electrical connection material
Operating instructions on CD
Available
accessories: Braking resistor, mains filter, mains chokes, output chokes, link circuit choke
(size 8 and above), EMC kit (SK EMV ...), electronic brake rectifier SK EBGR-
1), IO extension for SK 54xE (SK EBIOE-2), interface converter RS232
®
RS485 (supplementary description BU 0010), NORD CON PC
parameterisation software
> www.nord.com < , ePlan macros for creating
electrical circuit diagrams > www.nord.com <
Technology units for clipping onto the frequency inverter for control and
parameterisation or as communication interface for various bus systems.
Pos : 21 /Anl eitungen/ Elektroni k/FU und Start er/ 1. Allgemei nes/ 1. 4 Sicherheits- und Inst allati onshi nweis e @ 0\ mod_1325780428207_388. doc x @ 5385 @ 2 @ 1
1.4 Safety and installation information
NORD frequency inverters are equipment for use in industrial high voltage systems and are operated
at voltages that could lead to severe injuries or death if they are touched.
The frequency inverter and its accessories must only be used for the purpose which is intended by the
manufacturer. Unauthorised modifications and the use of spare parts and additional equipment which
has not been purchased from or recommended by the manufacturer of the frequency inverter may
cause fire, electric shock and injury.
All of the associated covers and protective devices must be used.
Installation and other work may only be carried out by qualified electricians with strict adherence to the
operating instructions. Therefore keep these Operating Instructions at hand, together with all
supplementary instructions for any options which are used, and give them to each user.
Local regulations for the installation of electrical equipment and accident prevention must be complied
with.
Pos : 22 /Anl eitungen/ Elektroni k/FU und Start er/ 1. Allgemei nes/ 1. 4. 1 Erl äuter ung der verwendet en Kennz eic hnungen @ 1\mod_1341559156309_388. doc x @ 30301 @ 3 @ 1