NORD Drivesystems BU0500 - Manual (Page 127)

5 Parameters
BU 0500 GB-1013 127
P549
Pot Box function
(PotentiometerBox function)
S
0 ... 16
{ 0 }
In this parameter, the setpoint of the PotentiometerBox (SK TU3-POT) is assigned with a
function. (An explanation can be found in the description of P400.)
As of software version 1.7 R0, on setting 4 or 5, the ControlBox or the ParameterBox are also set
to function as suppliers of auxiliary setpoints. (see Section 0)
0 = Off
1 = Setpoint frequency
2 = Torque current limit
3 = Actual frequency PID
4 = Frequency addition
5 = Frequency subtraction
6 = Current limit
7 = Maximum frequency
8 = Actual PID frequency limited
9 = Actual PID frequency monitored
10 = Servo mode torque
11 = Torque precontrol
12 = Reserved
13 = Multiplication
14 = Process controller actual value
15 = Process controller setpoint
16 = Process controller lead
Pos : 313 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P500-P599/ Paramet er P550 – C ontrol Box Auf träge @ 0\mod_1328098468764_388. doc x @ 12031 @ @ 1
P550
Back up data record
(Back up data record)
0 ... 3
{ 0 }
Within the optional ControlBox it is possible to save a data set (parameter set 1 … 4) of the
connected FI. This is saved in a non-volatile memory within the Box, and can therefore be
transferred for other SK 5xxE units with the same database version (see P742).
0 = No change
1 = FI à ControlBox, the dataset is written from the connected FI to the ControlBox.
2 = ControlBox à FI, the dataset is written from the ControlBox to the connected FI.
3 = FI ßà ControlBox, the FI dataset is exchanged with the ControlBox dataset. With this
variant, no data is lost. It is continuously exchangeable.
NOTE: If parameterisation from old FI's need to be loaded into FIs with new software (P707),
then the ControlBox must previously be written to by the new FI (P550 = 1). The
dataset to be copied from the old FI can then be read out and copied to the new FI.
Pos : 314 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P500-P599/ Paramet er P551 – Antriebs profil @ 0\ mod_1328098517139_388. doc x @ 12054 @ @ 1
P551
Drive profile
(Drive profile)
S
0 … 1
{ 0 }
According to the option the relevant process data profiles can be activated with this parameter.
Note Activation of profiles
This parameter is only effective for pluggable technology modules (SK TU3-…).
System CANopen DeviceNet InterBus
Technology module SK TUx-CAO SK TUx-DEV SK TUx-IBS
Setting
0 = OFF = USS protocol (Profile "Nord")
1 = ON = DS402 profile AC Drives profile Drivecom profile
Pos : 315 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P500-P599/ Paramet er P552 – C AN M ast er Z ykl usz eit @ 0\ mod_1328098574264_388. doc x @ 12077 @ @ 1