NORD Drivesystems BU0500 - Manual (Page 95)

5 Parameters
BU 0500 GB-1013 95
P403
Adjustment 1: 100%
(Analog input 1 adjustment: 100%)
S
-50.00 ... 50.00 V
{ 10.00 }
This parameter sets the voltage that should correspond with the maximum value of the selected
function for the analog input 1. In the factory setting (setpoint) this value is corresponds with the
setpoint set via P105 >Maximum frequency<.
Typical setpoints and corresponding settings:
0 – 10 V à 10.00 V
2 – 10 V à 10.00 V (monitored for function 0-10 V)
0 – 20 mA à 5.00 V (internal resistance approx. 250
W)
4 – 20 mA à 5.00 V (internal resistance approx. 250
W)
Pos : 185 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P400-P499/ Paramet er P400 ... P403 @ 0\ mod_1327681197866_388. doc x @ 9280 @ @ 1
P400 ... P403
P401 = 0 à 0 - 10V limited
0.0V 2.5V 5.0V 10.0V
P105
P104
P402 P403
output
frequency
setpoint
voltage
positive
P401 = 1 à 0 - 10V not limited
0.0V 2.5V 5.0V 10.0V
P105
P104
P402 P403
output
frequency
setpoint
voltage
positive
negative
Pos : 186 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P400-P499/ Paramet er P404 – Filter Anal ogeing ang 1 [ SK 500.. .535E] @ 0\mod_1327681251646_388.doc x @ 9303 @ @ 1
P404
Analog input filter 1
(Filter analog input 1)
S
1 ... 400 ms
{ 100 }
Adjustable digital low-pass filter for the analog signal. Interference peaks are hidden, the reaction
time is extended.
Pos : 188 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P400-P499/ Paramet er P405 – Funkti on Analogei ngang 2 [SK 500... 535E] @ 0\ mod_1327681361860_388. doc x @ 9349 @ @ 1
P405
Digital input 2 function
(Analog input 2 function)
P
0 ... 82
{ 0 }
This parameter is identical to P400.
Pos : 189 /Anleit ungen/5. / 6. Parametrier ung [BU 0500 / BU 0200]/ Par ameter/ P400-P499/ Paramet er P406 – M odus Analogei ngang 2 [SK 500... 535E] @ 0\ mod_1327681410936_388. doc x @ 9372 @ @ 1