NORD Drivesystems BU0500 - Manual (Page 27)

2 Assembly and installation
BU 0500 GB-1013 27
2.4 Snap-on mounting rail kit SK DRK1-…
The snap-on mounting rail set SK DRK1-1 enables size 1 or 2
frequency inverters to be mounted on a standard TS35 (EN 50022)
mounting rail.
Frequency inverter
type
Si
z
e
Type
Snap-on rail
mounting kit
Part. No.
SK 5xxE-250- …
SK 5xxE-750- …
1 SK DRK1-1 275999030
SK 5xxE-111- …
SK 5xxE-221- …
2 SK DRK1-2 275999040
Scope of delivery
1=
2=
3=
4=
5=
Adapter for snap-on rail mounting
Clamp
Spacer
Fastening plate
Screws(2x)
Assembly
1. Push the fastening plate (4) into the guide on the heat sink (arrow);
2. place the spacer plate (3) on the fastening plate (4);
3. connect the snap-on rail mounting adapter (1) and the components
(3) + (4) with screws (5).
During assembly, take care that the stirrup (2) points upwards (mains
connection side of the inverter).
Then the inverter can be clipped directly onto the snap-on rail. To
release the frequency inverter, the stirrup (2) must be pulled a few
millimetres out of the snap-on rail.
Pos : 35 /Anl eitungen/ Elektroni k/FU und Start er/ 2. M ont age und Ins tall ati on/ 2. 5 EMV- Kit [SK5xxE] @ 0\ mod_1325861952008_388.doc x @ 5825 @ 2 @ 1