HP Onboard Administrator - Manual (Page 113)

Enclosure management commands 113
DISABLE LLF
• Description:
Disables Link Loss Failover for Onboard Administrator Redundancy.
• Access level/Bay level::
Operator, Administrator
• Restrictions:
You must have Onboard Administrator permission to perform this command.
ENABLE DHCP_DOMAIN_NAME
• Command:
ENABLE DHCP_DOMAIN_NAME [<bay number> | ACTIVE | STANDBY]
• Description:
o Enables the DHCP domain name.
o This command requires that Dynamic DNS is enabled. If bay number is not specified, the command
will default to the OA where the command is being run.
o If the user has previously disabled the DHCP-supplied domain name, this command will cause the
specified OA to revert to using the DHCP domain name.
o If Dynamic DNS is enabled, then ENABLE will succeed, otherwise the ENABLE command will fail
with an error message: Dynamic DNS is not enabled.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
None
ENABLE GUI_LOGIN_DETAIL
• Command:
ENABLE GUI_LOGIN_DETAIL
• Description:
Enables extended enclosure information available in the GUI on the login page
• Access level/Bay level:
OA administrator, OA operator
• Restriction:
None
ENABLE LLF
• Command:
ENABLE LLF