Add snmp trapreceiver, Add snmp trapreceiver v3 – HP Onboard Administrator User Manual
Page 77
Enclosure network configuration commands 77
OA administrator
•
Restrictions:
o
SSHKEY is only available for the Administrator local account.
o
SSHKEY works only in script mode.
o
SSHKEY string is limited to 4KB on Onboard Administrator versions prior to 2.30.
o
SSHKEY string is limited to 8KB on Onboard Administrator version 2.30 and later.
o
This command is only valid in script mode.
o
When the Onboard Administrator is operating in FIPS Mode, the minimum RSA key length is 2048
bits, and the signature hash algorithm must be SHA1, SHA-224, SHA-256, SHA-384, or SHA-512.
ADD SNMP TRAPRECEIVER
•
Command:
ADD SNMP TRAPRECEIVER <host> ["<community name>"]
•
Description:
Adds a new trap receiver address to the SNMP configuration. Defaults for the traps are version v1 and
port 162. The SNMP Trap community string is set to public or the optional "<community name>". The
"<community name>" string, if specified, must be 1 to 20 characters in length. Acceptable characters
include any printable character excluding quotes and newlines.
•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
o
A maximum of eight IP addresses can be added to receive SNMP traps.
o
Only v1 traps are supported.
o
The <host> value can be an IPv4 address, an IPv6 address, or a DNS name (maximum of 64
characters).
o
IPv6 addresses must be typed without the network prefix length.
ADD SNMP TRAPRECEIVER V3
•
Command:
ADD SNMP TRAPRECEIVER V3 {<host> <user name>
[NoAuthNoPriv|authNoPriv|authPriv] [INFORM]}
•
Description:
Adds a new trap receiver address to the SNMP configuration. This command is an extension of the
existing ADD SNMP TRAPRECEIVER command. The additional V3 parameter indicates this command
is an SNMPv3 trap and requires addition parameters.
•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
o
Eight v1/2c traps and eight v3 traps are allowed, for a total of 16 traps.