HP Onboard Administrator - Manual (Page 87)

Enclosure network configuration commands 87
o If your FTP server does not support anonymous connections, you can specify a user name and
password in the format ftp://username:password@host/path/file.
• Access level/Bay level:
OA administrator
• Restrictions:
When the Onboard Administrator is operating in FIPS Mode, the minimum RSA key length is 2048 bits,
and the signature hash algorithm must be SHA1, SHA-224, SHA-256, SHA-384, or SHA-512.
ENABLE ALERTMAIL
• Command:
ENABLE ALERTMAIL
• Description:
Enables the sending of alert emails when an event occurs
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
You can only issue this command if the configuration has been set up.
ENABLE DHCPV6
• Command:
ENABLE DHCPV6
• Description:
Enables the active (and standby, if configured) Onboard Administrator to request a DHCPv6 IP address.
Allows DHCPv6 traffic on the enclosure management network. When this mode is enabled, all IPv6 and
DNS addresses are obtained from the DHCPv6 Server. If IPv6 is enabled, the ENABLE DHCPV6 setting
takes effect immediately. To enable IPv6, use the ENABLE IPV6 (on page 90 , " ENABLE EBIPAV6 " on
page 61 ) command.
NOTE: For DHCPv6 addresses to be successfully configured, the ENABLE DHCPv6 setting must
be enabled on the enclosure and a DHCPv6 server configured on the management network. iLOs
and interconnects must be configured separately to request a DHCPv6 address. If they are
configured to request DHCPv6 addresses, the ENABLE DHCPV6 and ENABLE IPV6 settings must
be enabled to allow the necessary traffic on the enclosure management network.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
For the ENABLE DHCPV6 setting to take effect, IPv6 must be enabled.
ENABLE ENCLOSURE_ILO_FEDERATION_SUPPORT
• Command: