HP Onboard Administrator - Manual (Page 119)

Enclosure management commands 119
The FRONT controller enables the internal DVD drive and the front USB connector.
The BACK controller enables the two USB ports on the rear of the KVM Option Module.
This command has no effect on c3000 Onboard Administrator boards that are hardware revision level
'CO' and later as displayed with SHOW OA INFO.
• Access level/Bay level:
OA Administrator
• Restrictions:
A small number of c3000 Onboard Administrator boards can use only one USB controller at a time.
SET POWER MODE
• Command:
SET POWER MODE {NOTREDUNDANT | REDUNDANT | POWERSUPPLY}
• Description:
o Configures redundancy settings.
o The NOTREDUNDANT setting enables all power supplies to function without regard for redundancy.
o The POWERSUPPLY setting enables one power supply to fail without being over committed on
power.
o The REDUNDANT setting enables half of the power supplies to fail without being over committed on
power.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
None
SET POWER LIMIT
• Command:
SET POWER LIMIT {<number> | OFF}
• Description:
Sets or removes a limit on how much input power can be consumed by the enclosure. This setting is
helpful if the enclosure receives power from a PDU with a limited power rating
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
None
SET POWER SAVINGS
• Command:
SET POWER SAVINGS {ON | OFF}