Enable remote_support irs, Enable remote_support maintenance – HP Onboard Administrator User Manual
Page 196
HP Insight Remote Support commands 196
) command to send a test event to confirm the connection between
OA and Insight Remote Support.
If your enclosure uses a web proxy server to access the Internet, enter proxy information with the SET
REMOTE_SUPPORT DIRECT PROXY (on page
) command.
•
Access level/Bay level:
OA administrator
•
Restrictions
Version 4.01 or later of the Onboard Administrator firmware must be installed.
ENABLE REMOTE_SUPPORT IRS
•
Command:
ENABLE REMOTE_SUPPORT IRS {"<hostname | IP address>" <port>}
•
Description:
Registers the Onboard Administrator enclosure for Remote Support Central Connect (IRS mode),
allowing the enclosure to communicate to HP through an HP Insight Remote Support centralized Hosting
Device in your local environment.
After registering, you can use the TEST REMOTE_SUPPORT (on page
) command to send a test
event to confirm the connection between Onboard Administrator and Insight Remote Support.
•
Access level/Bay level:
OA administrator
•
Restrictions
o
Insight Remote Support 7.0.5 or later must be installed and configured on the Insight Remote
Support centralized hosting device.
o
Version 3.60 or later of the Onboard Administrator firmware must be installed.
o
A valid certificate is required if connecting to an HP Insight Remote Support Hosting Device and the
Onboard Administrator is operating in FIPS Mode.
ENABLE REMOTE_SUPPORT MAINTENANCE
•
Command:
ENABLE REMOTE_SUPPORT MAINTENANCE { MIN | HOUR | DAY | WEEK } <interval>
•
Description:
Enables and starts the Remote Support maintenance window for the time interval specified
•
Access level/Bay level:
OA administrator
•
Restrictions:
Remote Support must be enabled before running ENABLE REMOTE_SUPPORT MAINTENANCE. This
setting is not recorded when you run the SHOW CONFIG command.