Upload config – HP Onboard Administrator User Manual
Page 139
Enclosure management commands 139
o
Updates the Onboard Administrator firmware using an image on a firmware CD. Enclosure
Firmware Management must be configured with a valid ISO URL.
o
Supported protocols are HTTP, FTP, and TFTP.
o
The URL must be formatted as: protocol://host/path/file.
o
The URL syntax for IPv4 addresses is protocol://<ipv4 address>/path/file.
o
The URL syntax for IPv6 addresses is protocol://[<ipv6 address>]/path/file.
o
If your FTP server does not support anonymous connections, you can specify a user name and
password in the format ftp://username:password@host/path/file.
o
Use FORCE to enable downgrading firmware even if settings and passwords might be lost.
o
The UPDATE IMAGE SYNC command initiates a firmware sync of the Active and Standby Onboard
Administrators.
o
For USB protocol, see the SHOW USBKEY (on page
) command.
•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
You cannot use the FORCE option for a downgrade in FIPS Mode ON/DEBUG.
CAUTION:
When a firmware upgrade is in process, do not disconnect the Onboard
Administrator modules. Disconnecting these modules could render the Onboard Administrator
unusable.
UPLOAD CONFIG
•
Command:
UPLOAD CONFIG {"<url>" | USB "<filename>"}
•
Description:
o
Uploads to the specified URL a script that duplicates the current runtime configuration.
o
Supported protocols are FTP, TFTP, and USB.
o
Format the URL as follows: protocol://host/path/file.
o
The URL syntax for IPv4 addresses is protocol://<ipv4 address>/path/file.
o
The URL syntax for IPv6 addresses is protocol://[<ipv6 address>]/path/file.
o
If your FTP server does not support anonymous connections, you can specify a user name and
password in the format ftp://username:password@host/path/file.
o
To save an Onboard Administrator configuration file to a USB key, use the USB keyword and
provide a file name.
•
Access level/Bay level:
OA administrator
•
Restriction:
The user password is not saved or restored by the UPLOAD CONFIG command.