Enable trusted host, Enable xmlreply, Remove oa address ipv6 – HP Onboard Administrator User Manual
Page 92
Enclosure network configuration commands 92
ENABLE TRUSTED HOST
•
Command:
ENABLE TRUSTED HOST
•
Description:
Enables IP security for the Onboard Administrator
•
Access level/Bay level:
OA administrator
•
Restrictions:
None
ENABLE XMLREPLY
•
Command:
ENABLE XMLREPLY
•
Description:
Enables XML reply data over an HTTP connection
•
Access Level/Bay Level:
OA administrator, OA operator
•
Restrictions:
None
REMOVE OA ADDRESS IPV6
•
Command:
REMOVE OA ADDRESS IPV6 {<bay number>} <ipv6 address/prefix length>
•
Description:
Removes the IPv6 static address for the Onboard Administrator. If IPv6 is enabled, then this command
takes effect immediately. If no Onboard Administrator number is provided, the command defaults to the
active Onboard Administrator.
•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
o
The prefix length is mandatory.
o
The <ip address> value must be in the form
####:####:####:####:####:####:####:####/###, where each #### ranges from 0 to FFFF.
A compressed version of the same IPv6 address is also supported. The prefix /### ranges from 0
to 128.