Set factory, Set script mode, Set urb – HP Onboard Administrator User Manual
Page 55
General management commands 55
SET FACTORY
•
Command:
SET FACTORY
•
Description:
o
Restores the Onboard Administrator to its factory defaults. The Administrator account password
does not change.
o
The Onboard Administrator restarts after all changes are made.
o
All existing settings are lost when this operation is run.
IMPORTANT:
Before resetting factory defaults, save your configuration. To upload a script
containing your current configuration, use the UPLOAD CONFIG (on page
) command. You
can use this script later to restore settings that are lost after a factory reset.
NOTE:
After a factory reset, the enclosure IPv6 network settings (IPv6, SLAAC, and DHCPv6) are
enabled by default.
•
Access level/Bay level:
OA administrator
•
Restrictions:
You cannot run SET FACTORY in FIPS Mode ON/DEBUG.
SET SCRIPT MODE
•
Command:
SET SCRIPT [MODE] {ON | OFF}
•
Description:
o
This command ceases all prompting and verifying of entries when SCRIPT MODE is on.
o
The ADD USER command must have a password argument if executed in SCRIPT MODE.
o
Default values are used for any parameters that would normally require user interaction.
o
This setting is only effective for the current CLI session.
•
Access level/Bay level:
All
•
Restrictions:
None
SET URB
•
Command:
SET URB [ URL | INTERVAL | PROXY URL | SMTPSERVER | MAILBOX ]
•
Description:
Sets settings for URB reporting
SET URB URL { <url> } sets the URB endpoint URL.