Set user fullname, Set user password, Show password settings – HP Onboard Administrator User Manual
Page 30
User account commands 30
o
You must use double quotes if the contact information contains any spaces.
SET USER FULLNAME
•
Command:
SET USER FULLNAME ["<user name>"] "<full name>"
•
Description:
Sets a user's full name. If you do not specify a <user name>, then the command modifies the full name
of the user who is currently logged in.
•
Access level/Bay level:
o
OA administrator
o
All users can modify their own full name.
•
Restrictions:
o
The <user name> is case sensitive. The <full name> must be a maximum of 20 characters long and
includes all alphanumeric, the dash, the underscore, and the space characters.
o
The default full name is blank.
SET USER PASSWORD
•
Command:
SET USER PASSWORD "<user name>" ["<new password>"]
•
Description:
Sets a user's password. If you do not supply a password on the command line, you are prompted for
one.
•
Access level/Bay level
OA administrator
OA operator and User access level users can change their own passwords.
•
Restrictions:
o
Only OA administrators can modify another user's password. Only the Administrator account can
modify the password of the Administrator account.
o
The <user name> is case sensitive.
o
The <password> must be 3 to 8 characters long for firmware 1.00 through 1.30 and 3 to 40
characters long for firmware 2.00 and later. When in FIPS Mode ON/DEBUG, the password
length must be between 8 and 40 characters. The minimum password length setting may be
overwritten through the SET MINIMUM PASSWORD LENGTH command.
o
When in FIPS Mode OFF, the character set includes all printable characters. When in FIPS Mode
ON/DEBUG, the password must contain at least one character from three of the four types of
characters. The four types are upper-case, lower-case, numeric, and non-alphanumeric.
SHOW PASSWORD SETTINGS
•
Command: