JLG 1100SB Service Manual User Manual
Page 125
SECTION 3 - CHASSIS & TURNTABLE
3121265
– JLG Lift –
3-83
replaced. If the housing has passed this inspection
the disassembly of the Torqlink™ is completed.
NOTE: The depth or location of bearing/bushing (13) in rela-
tion to the housing wear plate surface and the depth
or location of bearing/bushing (19) in relation to the
beginning of bearing/bushing counter bore should be
measured and noted before removing the bearings/
bushings. This will facilitate the correct reassembly
of new bearings/bushings.
22.
If the bearings, bushing or thrust washers must be
replaced use a suitable size bearing puller to
remove bearing/bushings (19) and (13) from hous-
ing (18) without damaging the housing. Remove
thrust washers (14) and thrust bearing (15) if they
were previously retained in the housing by bearing
(13).