Disassembly, Disassembly -54 – JLG 1100SB Service Manual User Manual
Page 224
Advertising
SECTION 4 - BOOM & PLATFORM
4-54
– JLG Lift –
3121265
Disassembly
1.
Remove the cap screws (113) over end cap lock
pins (109).
2.
Using a 1/8” (3.18mm) drill bit, drill a hole in the cen-
ter of each lock pin to a depth of approximately 3/
16” (4.76mm).
3.
Remove the lock pins using an ”Easy Out” (a size
#2 is shown).
If the pin will not come out with the ”Easy Out”, use
5/1
6” drill bit to a depth of 1/2” (12.7mm) to drill out
the entire pin.
4.
Install the end cap (4) removal tools provided with
the Helac seal kit.
5.
Using a metal bar, or something similar, unscrew the
end cap (4) by turning it counter clockwise.
Advertising