JLG 1100SB Service Manual User Manual

Page 387

Advertising
background image

SECTION 6 - JLG CONTROL SYSTEM

3121265

– JLG Lift –

6-103

8636

86

36

REAR LEFT STEER SENSOR - SHORT TO GROUND OR
OPEN CIRCUIT

There is a Short to Ground
or an Open Circuit to the
Rear Left Steer Sensor.

8637

86

37

REAR LEFT STEER SENSOR - SHORT TO BATTERY

There is a Short to Battery
to the Rear Left Steer Sen-
sor.

8651

86

51

ENGINE SHUTDOWN - AXLE LOCKOUT VALVE FAULT

Engine Start is prevented
while there is an Oscillating
Axle fault and vehicle is out
of transport position

990

99

0

<<< HARDWARE >>>

998

99

8

EEPROM FAILURE - CHECK ALL SETTINGS

The Ground Module has
reported an EEPROM fail-
ure.

9910

99

10

FUNCTIONS LOCKED OUT - PLATFORM MODULE SOFT-
WARE VERSION IMPROPER

The Platform Module soft-
ware version is not compat-
ible with the rest of the
system.

9914

99

14

PLATFORM MODULE SOFTWARE UPDATE REQUIRED

The Platform Module soft-
ware requires an updated.

9915

99

15

CHASSIS TILT SENSOR NOT GAIN CALIBRATED

The Chassis Tilt Sensor
gain calibration has been
lost.

9916

99

16

CHASSIS TILT SENSOR GAIN OUT OF RANGE

The Chassis Tilt Sensor
gain calibration has
become corrupted.

9917

99

17

HIGH RESOLUTION A2D FAILURE - INTERRUPT LOST

The Platform Module has
reported that its ADS1213
chip has stopped asserting
its interrupt.

9918

99

18

HIGH RESOLUTION A2D FAILURE - REINIT LIMIT

The Platform Module has
reported that its ADS1213
chip had to be reset 3 or
more times.

9919

99

19

GROUND SENSOR REF VOLTAGE OUT OF RANGE

The Ground Module has
reported that its sensor ref-
erence voltage is outside
acceptable range.

- Not reported during power-
up.

9920

99

20

PLATFORM SENSOR REF VOLTAGE OUT OF RANGE

The Platform Module has
reported that its sensor ref-
erence voltage is outside
acceptable range.

- Not reported during power-
up.

9921

99

21

GROUND MODULE FAILURE - HIGH SIDE DRIVER CUT-
OUT FAULTY

The Ground Module has
reported that its high side
driver cutout failed.

9922

99

22

PLATFORM MODULE FAILURE - HWFS CODE 1

The Platform Module has
reported that the V(Low)
FET has failed.

Table 6-6. Diagnostic Trouble Code Chart

DTC

Flash

Code

Sequence

Fault Message

Fault Description

Check

Advertising