Step 3: bleeding the platform valves, Step 3: bleeding the platform valves -55 – JLG 1100SB Service Manual User Manual
Page 339
Advertising
SECTION 6 - JLG CONTROL SYSTEM
3121265
– JLG Lift –
6-55
10.
Hit ENTER. The screen should read:
11.
Hit ENTER again to calibrate level sensors.
12.
When calibration has been successful CAL. COM-
PLETE should appear.
13.
Cycle power to the machine.
STEP 3: BLEEDING THE PLATFORM VALVES
1.
Position the Platform/Ground select switch to the
Ground position.
2.
Plug the analyzer into the connector inside the
Ground control box.
3.
Pull out the Emergency Stop switch and start the
engine.
Advertising