Boom sensor calibration position 10 -77 – JLG 1100SB Service Manual User Manual
Page 361
Advertising
SECTION 6 - JLG CONTROL SYSTEM
3121265
– JLG Lift –
6-77
Press Enter. The screen will read:
32.
Telescope in to green witness mark (controller will
find the position - operator must visually verify the
position).
When the boom is in the proper position, the screen
will read:
Press Enter. The screen will read:
33.
After completing all the Boom Sensors Calibrations,
hit ESC twice to go back to Calibrations.
34.
Cycle the emergency stop switch.
Figure 6-23. Boom Sensor Calibration Position 10
Advertising